DEM数据辅助的星载SAR俯仰向数字波束形成

叶恺; 禹卫东; 王伟

doi:10.11834/jrs.20197489

浏览量 : 0 下载量: 968 CSCD: 0

PDF
导出
分享
收藏
专辑

DEM数据辅助的星载SAR俯仰向数字波束形成
Digital beamforming in the elevation of Spaceborne SAR assisted by DEM data
2019年23卷第5期页码：850-858
收稿：2017-11-14，

录用：2018-6-13，

纸质出版：2019-09
DOI： 10.11834/jrs.20197489
稿件说明：

移动端阅览

叶恺, 禹卫东, 王伟. 2019. DEM数据辅助的星载SAR俯仰向数字波束形成. 遥感学报, 23(5): 850–858 DOI： 10.11834/jrs.20197489.

Ye K, Yu W D and Wang W. 2019. Digital beamforming in the elevation of Spaceborne SAR assisted by DEM data. Journal of Remote Sensing, 23(5): 850–858 DOI： 10.11834/jrs.20197489.

摘要

俯仰向数字波束形成(DBF)处理是星载合成孔径雷达(SAR)实现高分辨率宽测绘带成像的关键。然而，在处理较大地形起伏区域的回波信号时，传统俯仰向波束扫描(SCORE)方法会出现波束指向偏差问题，导致接收回波的增益降低，影响SAR系统成像性能。针对这一问题，本文详细分析了高分宽幅星载SAR系统的俯仰向DBF接收波束扫描指向问题，提出了一种基于数字高程图(DEM)的俯仰向DBF处理方法。该方法基于星载SAR成像几何模型，首先利用成像场景的DEM数据和卫星轨道参数计算距离门单元对应的地面高程值，并进一步计算距离门单元对应的目标波达角，然后根据该对应关系计算每个距离门单元的俯仰向DBF加权矢量，从而确保在俯仰向DBF处理过程中接收波束指向正确。通过X波段的星载SAR系统进行仿真实验，结果表明(1)当地面高程值大于1.9 km时，传统SCORE方法处理得到的目标信号幅度下降都超过2.8 dB，本文方法处理得到的目标信号幅度下降都小于0.4 dB，本文方法优于传统SCORE方法；(2)由DEM数据误差导致的地面目标高程偏差对本文方法影响较小。因此本文方法能够有效改善地形起伏较大区域的回波信号接收增益。

Abstract

Digital Beam Forming (DBF) in elevation plays a crucial role in spaceborne Synthetic Aperture Radar (SAR) by realizing the high-resolution wide-swath (HRWS) imaging mode. However

when dealing with echo signals in mountainous and relief areas

the traditional scan-on-receive (SCORE) approach in elevation always leads to the problem of beam mispointing. This problem leads to the reduction of system receiving gain

which affects the imaging performance of SAR systems. To address the problem of beam mispointing

this work proposes a DBF processing approach in elevation based on Digital Elevation Map (DEM). This work presents a detailed analysis on the steering direction of the DBF receiving beam. A processing procedure for the proposed approach consisting of three main steps is elaborated. First

on the basis of spaceborne SAR imaging geometry

the height of the target is computed for each range cell in SAR imagery by using the DEM data and satellite orbit parameters. Second

the direction of arrival (DOA) angle of the target is calculated for each range cell with the geometry model of earth. Third

according to the relationship between DOA angle of target and each range cell

the DBF weighted coefficients are computed for each range cell. This step enables the receiving beam to point to the signal source of the real target

thereby improving the receiving gain of echo signals. Finally

an X-band spaceborne SAR system is introduced for simulation experiments. Simulation results show that when the ground height is more than 1.9 km

the amplitude of the target signal processed by the traditional SCORE method is attenuated more than 2.8 dB. After the proposed method is used

the target signal amplitude is attenuated less than 0.4 dB. Thus

the proposed method is superior to the traditional SCORE method. The influence of DEM error on the DBF processing method in elevation is also analyzed. As the acquired DEM data have adequate height accuracy

DEM errors have minimal influence on the proposed approach. Taking full consideration of spaceborne SAR imaging geometry model and DEM data of the ground scene

the proposed method can correct the DBF receiving beam pointing deviation in mountainous areas. The proposed method has the potential to promote the application of DBF processing in spaceborne SAR.

关键词

Keywords

references

Bordoni F, Younis M, Varona E M and Krieger G. 2009. Adaptive digital beam-forming algorithm for high-resolution, wide-swath synthetic aperture radar//International Radar Symposium. Berlin, Germany: [s.n.]: 1-5

Bueso-Bello J L, Martone M, Prats-Iraola P and Bräutigam B. 2016. First characterization and performance evaluation of bistatic TanDEM-X experimental products. IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing, 9(3): 1058–1071

陈尔学. 2004. 星载合成孔径雷达影像正射校正方法研究. 北京: 中国林业科学研究院: 123-150

Chen E X. 2004. Study on Ortho-rectification Methodology of Space-borne Synthetic Aperture Radar Imagery. Beijing: Chinese Academy of Forestry: 123-150

Cumming I G and Wong F H. 2005. Digital Processing of Synthetic Aperture Radar Data: Algorithms and Implementation. Norwood, MA: Artech House: 3-168

Curlander J C. 1982. Location of Spaceborne SAR imagery. IEEE Transactions on Geoscience and Remote Sensing, GE-20(3): 359-364

Freeman A, Johnson W T K, Huneycutt B, Jordan R, Hensley S, Siqueira P and Curlander J. 2000. The " Myth” of the minimum SAR antenna area constraint. IEEE Transactions on Geoscience and Remote Sensing, 38(1): 320–324

Gruber A, Wessel B, Huber M, Breunig M, Wagenbrenner S and Roth A. 2012. Quality assessment of first TanDEM-X DEMs for different terrain types//Proceedings of the 9th European Conference on Synthetic Aperture Radar. Nuremberg: IEEE: 101-104

Krieger G, Gebert N and Moreira A. 2008. Multidimensional waveform encoding: a new digital beamforming technique for synthetic aperture radar remote sensing. IEEE Transactions on Geoscience and Remote Sensing, 46(1): 31–46

Krieger G, Huber S, Villano M, De Almeida F Q, Younis M, Lopez-Dekker P, Prats P, Rodriguez-Cassola M and Moreira A. 2016. SIMO and MIMO system architectures and modes for high-resolution ultra-wide-swath SAR imaging//Proceedings of EUSAR 2016: 11th European Conference on Synthetic Aperture Radar. Hamburg, Germany: IEEE: 1-6

Krieger G, Moreira A, Fiedler H, Hajnsek I, Werner M, Younis M and Zink M. 2007. TanDEM-X: a satellite formation for high-resolution SAR interferometry. IEEE Transactions on Geoscience and Remote Sensing, 45(11): 3317–3341

Krieger G, Younis M, Gebert N, Huber S, Bordoni F, Patyuchenko A and Moreira A. 2010. Advanced concepts for high-resolution wide-swath SAR imaging//Proceedings of the 8th European Conference on Synthetic Aperture Radar. Aachen, Germany: IEEE: 1-4

Moreira A, Krieger G, Hajnsek I, Papathanassiou K, Younis M, Lopez-Dekker P, Huber S, Villano M, Pardini M, Eineder M, De Zan F and Parizzi A. 2015. Tandem-L: a highly innovative bistatic SAR mission for global observation of dynamic processes on the earth’s surface. IEEE Geoscience and Remote Sensing Magazine, 3(2): 8–23

Rabus B, Eineder M, Roth A and Bamler R. 2003. The shuttle radar topography mission——a new class of digital elevation models acquired by spaceborne radar. ISPRS Journal of Photogrammetry and Remote Sensing, 57(4): 241–262

Suess M, Grafmueller B and Zahn R. 2001. A novel high resolution, wide swath SAR system//Proceedings of the Scanning the Present and Resolving the Future. Proceedings of the IEEE 2001 international Geoscience and Remote Sensing Symposium. Sydney, NSW, Australia: IEEE: 1013-1015

Suess M and Wiesbeck W. 2001. Side-looking synthetic aperture radar system. European Patent, EP1241487B1

Varona E M. 2009. Adaptive Digital Beam-forming for High-resolution Wide-swath Synthetic Aperture Radar. Barcelona: University Politècnica of Catalonia: 31-42

Younis M, Fischer C and Wiesbeck W. 2003. Digital beamforming in SAR systems. IEEE Transactions on Geoscience and Remote Sensing, 41(7): 1735–1739

Younis M, Huber S, Patyuchenko A, Bordoni F and Krieger G. 2009. Performance comparison of reflector- and planar-antenna based digital beam-forming SAR. International Journal of Antennas and Propagation, 2009: 614931

文章被引用时，请邮件提醒。

提交

月基观测地球辐射能量和固体潮的作用与潜力

合成孔径雷达分析就绪数据（SAR ARD）：进展、挑战与展望

合成孔径雷达月球探测研究进展

联合超像素分割和显著性特征的SAR海洋内波检测

适应复杂区域的时序SAR影像洪水监测与分析